UHU Plast Special 30g/34ml

Product description
UHU plast special is a special liquid glue for assembling polystyrene and a wide
range of plastic materials with a fine needle-shaped nozzle that enables very
precise application as well as access to parts that are difficult to reach. A thin
liquid adhesive which forms a tough elastic and cystal clear adhesive film.

Field of application
UHU plast special give an excellent bond on a number of plastics such as
polystyrene and impact polystyrene types (ABS, SAN, SB, ASA), polyvinyl
chloride (PVC) hard and soft, Plexiglas (PMMA), Celluloid, cellulose ester
(CN, CAB), polycarbonate (PC). Additionally, UHU plast fluid/special also glue
other materials such as wood, paper, cardboard (in connection with the above
mentioned plastics). Not suitable for polyamide (PA), acetal resin (POM),
polyethylene (PE), polypropylene (PP), polytetrafluoroethylene (PTFE), silicon
(Si) and foamed polystyrene (is attacked).

Properties
· forms a hard but flexible bonding film with a thermoplastic character
· Temperature resistant from –30°C to approx. +90°C as well as against water,
oil, petrol and alcohol.
· The following maximum values were determined:
Plexiglas 3.0 N/mm²
polystyrene 3.4 N/mm²
hard PVC 4.3 N/mm²
polycarbonate 4.5 N/mm²
ABS 6.5 N/mm² material rupture

Preparation
Personal safety: UHU plast special contain volatile, highly flammable solvents.
Therefore corresponding safety measures should be taken regarding processing
and storage.
Surface requirements: The surfaces must be clean, dry and free of oil, grease
and dust.

Application
Directions for use:
Depending on the requirement, apply to one or both of the materials to be
joined and stick together immediately. An initial bond strength is attained after
5 - 10 minutes. The high bond strength of UHU plast fluid/special is attained by
melting the plastic surface. For this reason, the adhesive should only be applied
in small quantities to thin walled plastics.
Stains/residue: Smeared adhesive and stains can be removed with acetone or
thinner for nitrocellulose lacquer.

Technical specifications
Specifications:
Consistency: very low viscosity
Solid content [%]: 8 - 10
Danger class (VbF): A l
Flash point [°C]: approx. +7

Physiological properties
The dried adhesive is stable, neutral and physiologically safe.

Pack sizes
plast special plastic bottle with nozzle 30g